This is a construct which expresses blue fluorescence after the Las receptor binds with 4-C AHL. It acts as a biosensor in our project.
RBS.1 (strong) -- modified from R. Weiss
Strong RBS based on Ron Weiss thesis. Strength is considered relative to <bb_part>BBa_B0031</bb_part>, <bb_part>BBa_B0032</bb_part>, <bb_part>BBa_B0033</bb_part>.
Varies from -6 to +1 region from original sequence to accomodate BioBricks suffix ("orig" in figure 4-14 of Ron Weiss thesis). No secondary structures are formed in the given RBS region. Users should check for secondary structures induced in the RBS by upstream and downstream elements in the +50 to -50 region, as such structures will greatly affect the strength of the RBS. Contact info Brian Chow
Vinay S Mahajan, Voichita D. Marinescu, Brian Chow, Alexander D Wissner-Gross and Peter Carr IAP, 2003.
Double terminator consisting of BBa_B0010 and BBa_B0012
lasR activator from P. aeruginosa PAO1(+LVA)
Genbank: NC_002516 (www.ncbi.nlm.nih.gov)
coding region for lasR protein, which accepts chemical signal AI-1 (made by lasI protein)
Mutated 480 from g to a to remove PstI site
"Analysis of the Pseudomonas aeruginosa Elastase (lasB) Regulatory Region". Lynn Rust, Everett Pesci, and Barbara Iglewski
Binding region for LasR protein (positive regulation)
Subach, O. M., I. S. Gundorov, et al. (2008). "Conversion of red fluorescent protein into a bright blue probe." Chem Biol 15(10): 1116-24.
This part codes for the bright blue fluorescent protein mTagBFP. mTagBFP is a monomeric protein with a narrow fluorescence emission spectrum with a maximum at 456 nm. It has a tyrosine-based chromophore, giving it substantially higher brightness, faster chromophore maturation and higher pH stability than blue fluorescent proteins with a histidine in the chromophore. Subach et. al. started with a red fluorescent protein (TagRed) and converted it to a bright blue monomeric protein. See the article listed in source. The sequence has been codon optimized for expression in E coli by DNA 2.0.
The sequence has been codon optimized for expression in E coli by DNA 2.0.
Derived from the TE terminator of T7 bacteriophage between Genes 1.3 and 1.4 <genbank>V01146</genbank>.
Transcription terminator for the E.coli RNA polymerase.
Suggested by Sri Kosuri and Drew Endy as a high efficiency terminator. The 5' end cutoff was placed immediately after the TAA stop codon and the 3' end cutoff was placed just prior to the RBS of Gene 1.4 (before AAGGAG). Use anywhere transcription should be stopped when the gene of interest is upstream of this terminator.
Transcriptional terminator consisting of a 64 bp stem-loop.
Conversion of the iGEM parts registry to SBOL2.1