Plasmid 2 (SDP) for the riboregulator delay circuit. The addition of IPTG will induce the production of key3c which allows the translation of cI in the plasmid 1 (BBa_K175023). cI induces the expression of GFP
Derived from the TE terminator of T7 bacteriophage between Genes 1.3 and 1.4 <genbank>V01146</genbank>.
Transcription terminator for the E.coli RNA polymerase.
Suggested by Sri Kosuri and Drew Endy as a high efficiency terminator. The 5' end cutoff was placed immediately after the TAA stop codon and the 3' end cutoff was placed just prior to the RBS of Gene 1.4 (before AAGGAG). Use anywhere transcription should be stopped when the gene of interest is upstream of this terminator.
The Plac insert was PCR'd from the MG1655 strain of E.coli K12.
Inverting regulatory region controlled by LacI (<bb_part>BBa_C0010</bb_part>, <bb_part>BBa_C0011</bb_part>, etc.) The pLac regulatory region is a 243 base-pair sequence with standard BioBrick prefix and suffix sections on its ends. It contains two protein binding sites: CAP, which is generally present in E.coli and is assocciated with cell health and availability of glucose., and LacI, the Lac inhibitor <bb_part>BBa_C0010</bb_part> which binds in an dimerized cooperative manner to inhibit the transcription of the protein that follows. In the presence of lactose or IPTG, an analog of lactose, LacI is unable to correctly bind and inhibit transcription. This allows <bb_part>BBa_R0010</bb_part> to be used as a inverter or as a detector of lactose or IPTG.
LacI binds to this regulator. This part is incompatible with species containing active LacI coding regions. Lactose and IPTG disable the operation of LacI and this regulator. This part is incompatible with environments containing lactose or lactose analogs.
Transcriptional terminator consisting of a 64 bp stem-loop.
RBS.1 (strong) -- modified from R. Weiss
Strong RBS based on Ron Weiss thesis. Strength is considered relative to <bb_part>BBa_B0031</bb_part>, <bb_part>BBa_B0032</bb_part>, <bb_part>BBa_B0033</bb_part>.
Varies from -6 to +1 region from original sequence to accomodate BioBricks suffix ("orig" in figure 4-14 of Ron Weiss thesis). No secondary structures are formed in the given RBS region. Users should check for secondary structures induced in the RBS by upstream and downstream elements in the +50 to -50 region, as such structures will greatly affect the strength of the RBS. Contact info Brian Chow
Vinay S Mahajan, Voichita D. Marinescu, Brian Chow, Alexander D Wissner-Gross and Peter Carr IAP, 2003.
green fluorescent protein derived from jellyfish Aequeora victoria wild-type GFP (SwissProt: P42212
GFP (mut3b) [note that this part does not have a barcode]
[key3c] riboregulator for lock3 variants
This part has the same homology region to J01122 as J23007 except that unlike J23007, J23008 does not contain the hairpin that was derived from J01129. J23008 anneals linearly to the stem of the hairpin in J01122 with perfect base pairing and destroys the hairpin in the process and reveals the RBS on J01122. When J01122 is transcribed the RNA secondary structure is such that the RBS hairpins with sequence upstream preventing the ribosome from binding and translation from occuring thereby locking up RFP further down stream. When J23008 is introduced into the cell in trans, we suspect that it will unlock the RBS for RFP as described above allowing translation to occur.
Modified lamdba Prm promoter (repressed by 434 cI)
Lamdba Prm promoter modified to be activated by lamda repressor (cI) and repressed by 434 repressor (cI)
The O-R1 region of 434 contained 14 base pairs as opposed to the 17 base pairs of the O-R3 site of lambda. Also, it was noticed that the O-R3 site of the lambda included part of the -10 site. Hence, to preserve the spacing and the -10 site, the three nucleotides that were in both the -10 site and the lambda O-R3 site were retained. The 14 nucleotides that were in the O-R3 site and not in the -10 site were replaced with the O-R1 site of the 434.
Conversion of the iGEM parts registry to SBOL2.1