This design is projected to exhibit XOR logic. The inputs are high osmolarity and 3OC6.
Derived from the TE terminator of T7 bacteriophage between Genes 1.3 and 1.4 <genbank>V01146</genbank>.
Transcription terminator for the E.coli RNA polymerase.
Suggested by Sri Kosuri and Drew Endy as a high efficiency terminator. The 5' end cutoff was placed immediately after the TAA stop codon and the 3' end cutoff was placed just prior to the RBS of Gene 1.4 (before AAGGAG). Use anywhere transcription should be stopped when the gene of interest is upstream of this terminator.
RBS.3 (medium) -- derivative of BBa_0030
Weak1 RBS based on Ron Weiss thesis. Strength is considered relative to <bb_part>BBa_B0030</bb_part>, <bb_part>BBa_B0031</bb_part>, <bb_part>BBa_B0033</bb_part>.
Varies from -6 to +1 region from original sequence to accomodate BioBricks suffix ("RBS-2" in figure 4-14 of thesis). Contact info for this part: Brian Chow
Vinay S Mahajan, Voichita D. Marinescu, Brian Chow, Alexander D Wissner-Gross and Peter Carr IAP, 2003.
Transcriptional terminator consisting of a 64 bp stem-loop.
green fluorescent protein derived from jellyfish Aequeora victoria wild-type GFP (SwissProt: P42212
GFP (mut3b) [note that this part does not have a barcode]
Reverse RBS (RBSrev) -- corresponds to BBa_B0030
Repeats in oligos caused unusual products during cloning
PCR was used to isolate the promoter and add BioBrick ends to it.
pOmpC is the promoter upstream of the OmpC gene which is native to E. coli. pOmpC is induced by high osmolarity, such as LB media and high sucrose concentration.
RFP reverse was PCR amplified from mRFP (BBaE1010).
The mRFP coding sequence in the reverse orientation. This part requires a reverse RBS and reverse promoter to be expressed
RFP reverse was PCR amplified from mRFP (BBaE1010) using the following primers: 5'-atgcactagtatggcttcctccgaagacgt "Spe mRFP F" 5'-gcattctagattaagcaccggtggagtgac "Xba mRFP R"
This is pLux oriented in an opposite direction to typical BioBrick inserts.
Had trouble getting this part via PCR. That was probably due to an error in the primers.
Conversion of the iGEM parts registry to SBOL2.1